KerfMeister

kerfmeister · for laser cutters

Measure your kerf.
Then prove it fits.

Kerf belongs to a machine and material pair, not to a laser alone. Cut one test coupon, measure the hole and the square that drops out of it, and KerfMeister works out your X and Y kerf per side.

free in your browser SVG files mm
A 65 by 80 mm kerf coupon cut from plywood: a 25 mm square window, small engraved dots at the middle of each edge to guide the calipers, and the machine, material and cut settings engraved around it.

how it works

One coupon. Two numbers. Three fit tests.

It all happens on one page at kerfmeister.com, with nothing to install and no account.

1 · cut

Cut one coupon

Enter your machine, material, thickness and cut settings, then download a 65 × 80 mm coupon engraved with them and a coupon code. Cut it with the laser's kerf offset turned off.

2 · measure

Copy X and Y

Measure the window and the dropped square with calipers at the engraved guides. KerfMeister turns the four readings into X and Y kerf per side, ready to paste into any app or laser software that applies kerf, with an average for software that takes only one offset.

3 · prove

Prove the fit

Cut thickness gauge cards, a finger joint test and an inlay test at that kerf. Each one carries the coupon code, so every test piece matches back to its coupon.

A thickness gauge card: a strip with ten slots of slightly different widths. The finger joint test: two square plates with fingers on every edge. The inlay test: a plate with a hexagon hole and a triangle hole, and the two pieces that fit them.

why it's free

It costs nothing. Tips are appreciated.

KerfMeister is free to use, the whole of it. There is no subscription, no paid tier and no advertising, and your inputs stay in your own browser.

If it saved you material or time, you can leave a tip. It is a thank-you for the tool, never an obligation, and it is always appreciated.